Devon's Trusted
Emergency Plumber company

A sump pump is an appliance that is used to help prevent flooding in your home. If you’re in a flood zone and your basement floods regularly, if you have older plumbing, or if you just want to take a proactive step against flooding, then a sump pump installation is right for you. Sump pumps help prevent flood damage in your home by detecting increasing water pressure or water levels. If high levels are detected, the sump pump will pump water out of your basement and away from your home to a better location like a storm drain or a well.

Sump pumps need annual maintenance. Like other appliances in your home, a sump pump should be maintained and serviced on a yearly basis. In some cases, more maintenance may be required. It is important to stay on top of sump pump maintenance in order to prevent a disaster. Oftentimes, homeowners will not notice that their sump pump isn’t working until it’s too late. Suddenly, when the sump pump is required, the homeowner discovers that it isn’t working as it should be. Many professional plumbing contractors provide Service Partner Plans that can help you properly maintain your appliances. An annual maintenance plan like this will ensure that your sump pump is always in top working condition.

There are several preventive measures you can take:

• Insulate your pipes, especially those in unheated areas like basements, garages, and crawl spaces.
• Keep your home’s thermostat set to a consistent temperature, even at night and when you’re away.
• Allow faucets to drip slightly during extremely cold spells to keep water flowing.
• Open cabinet doors under sinks to allow warm air to circulate around the pipes.

In Edmonton, you can expect to pay approximately $3,000 – $7,000 for a new water heater to be installed. This estimate includes the price of a high quality hot water tank, as well as installation. Keep in mind, the cost to have a professional Edmonton plumbing services provider install a water heater in your home will depend on the complexity of the installation, and the hot water tank you choose to purchase. For a simple job in which one hot water tank is being replaced by a new tank of the same type, the labour costs will not be too high. However, if you are having a hot water heater installed in a new location or in a home that does not currently have one, you will be looking at a more difficult job and therefore a higher price.

Absolutely! ProSolutions Inc. specializes not only in repairing burst pipes but also in preventive measures. Our experienced technicians can inspect your plumbing system, identify potential problem areas, and provide solutions to prevent pipes from freezing and bursting.

Tankless water heaters have many benefits over traditional hot water tanks however, the truth is, a tankless water heater is not worth it for everyone. Any professional plumbing company can tell you that a tankless hot water system is best for homes that don’t often use large amounts of hot water. For example, if you often take baths in a large tub, or you have numerous high-volume shower heads in your shower, then an on-demand hot water system may not be worth it. On the other hand, a tankless hot water heater will save you money over time, you won’t run out of hot water and it will last much longer than a traditional hot water tank. Consult your local tankless water heater plumber and they can help you decide whether a tankless water heater is right for you.

There are several common signs that your hot water tank may stop working. Consider calling a water heater services company to take a look at and repair or replace your unit if: 

1. Your unit is getting old. The average water heater will last 8 to 10 years. 
2. Your water smells or is discoloured. For example, if the water looks rusty the unit may be corroding. 
3. You hear loud noises coming from your hot water heater. Loud popping or crackling sounds can mean sediment has built up in the tank.
4. Your tank is leaking or you notice water around the water heater.
5. Your hot water tank no longer provides enough hot water.
6. The water pressure has gone down and is not sufficient.

If your drain is clogged with hair, baking soda can dissolve hair in a drain. 

To try this safe and easy method at home – first, pour a cup of baking soda down the drain. Then pour a cup of vinegar (white vinegar) down. Allow the mixture to sit for several minutes. Keep an eye out for bubbling in the drain (this is caused by the reaction between the baking soda and vinegar). Once the bubbling stops, wait a few more minutes then pour some boiling water down the drain. Repeat until the clog is cleared. Keep at it, it can take a long time.

With a heavy-duty clog, you might need something more powerful. In this case, try snaking the drain, plunging it or calling a local Edmonton drain cleaning company to get the job done.